[PrintOwners] Laser printer dimensional accuracy?

[Ian Franks]

Steve
We are have the same problems on kimoleks also known as laser positives. The
paper prints are fine. We are now running them as paper and not board it is
better.

On 01/02/2008, Steve Blatman <slb at inkspot.net> wrote:
>
> We've noticed that our HP5100 laser printer is less dimensionally
> accurate than I'd thought. What seems counterintuitive, though, is
> that the dimensions seem accurate along the length of the print, but
> run a bit long across the width. Since the drum doesn't change length
> as it rotates, I'd expect the opposite.
>
> Any thoughts on what's reasonable to expect for dimensional accuracy?
>
> Any pointers to a work-around or software solution, if this is normal
> behavior for laser printers?
>

-- 
Regards
Ian Franks
Print Image
3 Corlett Drive, Illovo, JHB
Ph 011 447 3133
Fax 011 447 0642
sales at printimage.co.za
www.printimage.co.za